ARGOREV HCG PRO GRX

About this product

Single-layer render mortar (GP) CSIII W2 sprayable, formulated with Portland cement, aggregates of compensated granulometry, mineral fillers and additives, suitable for interior and exterior thick-layer rendering. Grey version manufactured with cement CEM I 42.5 R suitable for marine environments.

Waterproofed

Waterproof to rain water.

Permeable to water vapour.

Thixotropic.

The thick layer plastering work on the enclosure will be carried out with ARGOREV® HCG PRO GRX sprayable dry mortar, from the company DANOSA, of class GP CSIII W2 according to the UNE EN 998-1 standard. The fixing substrate must be sound, clean, free of friable parts, completely hardened and shall have completed its time of dimensional variation. The construction joints shall be respected.

Mortar renderings.

Brick or ceramic block factory.

Concrete (treated with a bonding bridge).

In case of heat, wind or on very absorbent substrates, it is advisable to dampen the substrate and wait for the water film to disappear.

Do not apply on plasters or paints.

The support must be healthy, clean, flat, free of paint, crumbling or poorly adhered parts, release agents, etc. and in general without any substance or particle that may prevent correct adherence.

Mix ARGOREV® HCG PRO GRX with approx. 5 L of clean water per 25 kg bag manually or mechanically until a homogeneous, creamy and lump-free mixture is obtained.

Spread the mortar to an average thickness of 8-12 mm and smooth the applied material to even out the thickness and smooth the surface.

Once the hardening process has begun, proceed to trowel the material.

Comply at all times with the provisions of chapter 7 “Site work, preparation and application of plaster” of the UNE EN 13914-1 standard “Design, preparation and application of exterior plaster and interior plaster”.

Store in a dry place, protected from rain, sun, high and low temperatures.

It is advisable to mesh the application at singular points.

In case of splashes in the eyes, rinse with plenty of water and seek medical attention if necessary. For more detailed information see safety data sheet.

Do not apply when there is a risk of rain or frost.

Do not add more water once it has started to set.

Comply with the mixing water.

On very porous substrates prime with DANOPRIMER® RPU.

It is packaged in 25 kg multi-leaf paper bags with damp-proof sheets that allow it to be stored for 12 months in its original sealed packaging, safe from dampness.

Consult the safety data sheet.