ARGOREV RASPADO

About this product

ARGOREV RASPADO is a single coat mortar for facade cladding - OC CSIII W2 - based on white cement, selected aggregates and organic additives that give it an extraordinary thixotropy, adherence and a high aesthetic finish,

Indoor and outdoor.

Realization of coatings on facades on ceramic enclosure.

Rehabilitation and new construction with scraped or rustic finish.

Waterproofed

Waterproof to rain water.

Permeable to water vapour.

Projectable.

Without off-hook.

Thixotropic.

Direct application on masonry.

Colour chart.

Lightened.

The single-layer cladding work on the façade will be carried out with ARGOREV® RASPADO dry mortar, from the company DANOSA, class OC CSIII W2 in accordance with the UNE EN 998-1 standard. The substrate must be sound, clean, free of friable parts, completely hardened and have completed its time of dimensional variation. The construction joints shall be respected.

Mortar renderings.

Brick or ceramic block factory.

Concrete (treated with a bonding bridge).

In case of heat, wind or on very absorbent substrates, it is advisable to dampen the substrate and wait for the water film to disappear.

Do not apply on plasters or paints.

The support must be healthy, clean, flat, free of paint, crumbling or poorly adhered parts, release agents, etc. and in general without any substance or particle that may prevent correct adherence.

Mix ARGOREV® RASPADO with 4.5 L of clean water per 25 kg bag manually or mechanically until a homogeneous, creamy and lump-free mixture is obtained.

For mechanical application it is necessary to establish the optimum ratio between the water flow rate and the amount of mortar passing the auger.

Spread the mortar with the trowel or spray it in cords from the bottom upwards, leaving an average thickness of not less than 12 mm and not more than 15 mm after marking the wall’s cut-outs.

Regulate the material to regularise the thickness.

Once the hardening process has begun, proceed to trowel the material.

Comply at all times with the provisions of chapter 7 “Site work, preparation and application of plaster” of the UNE EN 13914-1 standard “Design, preparation and application of exterior plaster and interior plaster”.

Store in a dry place, protected from rain, sun, high and low temperatures.

It is advisable to mesh the application at singular points.

When applied at very high relative dampness, drying may be delayed.

In case of splashes in the eyes, rinse with plenty of water and seek medical attention if necessary. For more detailed information see safety data sheet.

Do not apply when there is a risk of rain or frost.

Do not add more water once it has started to set.

Comply with the mixing water.

It is packaged in 25 kg multi-leaf paper bags with damp-proof sheets that allow it to be stored for 12 months in its original sealed packaging, safe from dampness.

Consult the safety data sheet.