DANOPOL 250 VAPOUR BARRIER

About this product

A transparent 0.25mm vapour barrier made of low density polyethylene (LDPE) sheet. Designed mainly for roof systems but can be specified for other uses by the Danosa Technical Team.

Recommended as a barrier from the passage of water vapour, favouring its diffusion, both in the field of building and civil works.

The vapour barrier is laid floating, without the need for fixings or welding, overlapping by at least 10 cm.

This product may form part of a waterproofing system, so all the documents referred to in the Danosa Solutions Manual must be taken into account, as well as all the regulations and legislation that must be complied with in this respect.

Special attention must be paid to the execution of the singular points, such as parapets (meetings with vertical and emergent elements), drains, expansion joints, etc.

The product must be stored in a dry place protected from rain, sun, heat and low temperatures.

This product is not toxic or flammable.

Easy to cut to adapt the dimensions to the work.

No welding work should be carried out when the ambient temperature is lower than -5ºC for hot air welding, nor lower than + 5ºC for welding with THF or with Adhesives.

It shall be kept in its original packaging, in a horizontal position and all rolls parallel (never crossed), on a flat and smooth support.

Danosa recommends consulting the safety data sheet for this product, which is permanently available at www.danosa.com, Knowlegde Portal, or it can be requested from our Technical Department.

In all cases, the Occupational Safety and Hygiene standards, as well as the standards of good construction practice, must be taken into account.

In accordance with the UNE-EN 13984 standard for flexible sheets for waterproofing. Plastic and rubber sheets for vapour control. Definitions and characteristics.