Chain slings grade 100 - VIP: Swivel elements

About this product

Innovation and quality made by RUD: The highly dynamic chains and components of RUD product line VIP stand for up to 30 percent higher WLL than the highest grade 8 (grade 80) available until then. And with the same chains diameter. VIP-Chains are always one nominal thickness thinner – and therefore up to 50 percent lighter. The geometric structure and the tolerances of the VIP-Chains are adapted to those of the higher grade. The chain spectrum ranges from 4 to 28 mm and from 0.63 t (MINI single-strand) to 126 t (2 x MAXI double-strand).

VIP-Universal-swivel UW-PP VIP-Universal swivel PowerPoint. - The DGUV rule prescribes: Lifting means must not be twisted before lifting – this is done automatically by UW-PP. Ball-bearing mounted – rotatable under load! - Not suitable for permanent operation under full load. - Patented clevis connection design! Thus universal connection – loadable on all sides – shortest possible combinations. Only mount RUD approved VIP-Chains and components. - VIP-COBRA eye hooks VCÖH. - B-link for PowerPoint PP-(WLL)-B. Note: The VIP-Chain connection is non-mix-up. Pay attention to the correct WLL assignment for assembly 1 + 2! - 1 Safety factor (e. g. 4:1) for lifting means (safety against breakage). - All load-bearing elements are 100 % electromagnetically crack-tested. - Operating temperature range of the lifting means without permanent reduction of load capacity. - Maximum operating temperature of the lifting means with percentage, product-dependent load capacity reduction. - Component has been approved by the DGUV (German Social Accident Insurance) and has the corresponding certificate. - Easy testing and documentation. With the RUD BLUE-ID system (equipped with an RFID chip). - The lifting point can be rotated by 360°. However, this is not to be equated with rotating and turning under load! - Ball bearing: suitable for rotating and turning. However, not suitable for permanent turning movements under load!

VIP-Swivel connector VWA VIP-Swivel connector. - The DGUV rule prescribes: Lifting means must not be twisted before lifting – this is done automatically by VWA. - Ball-bearing mounted – rotatable under load! - Not suitable for permanent operation under full load.Can be mounted non-mix-up thanks to the adapter bar with all VIP-Clevis connection parts. Non-susceptible to dirt thanks to seal. NO WLL on bending. Install the VWA so that no bending can occur on the adapter during use. - 1 Safety factor (e. g. 4:1) for lifting means (safety against breakage). - All load-bearing elements are 100 % electromagnetically crack-tested. - Operating temperature range of the lifting means without permanent reduction of load capacity. - Maximum operating temperature of the lifting means with percentage, product-dependent load capacity reduction. - Easy testing and documentation. With the RUD BLUE-ID system (equipped with an RFID chip). - The lifting point can be rotated by 360°. However, this is not to be equated with rotating and turning under load! - Ball bearing: suitable for rotating and turning. However, not suitable for permanent turning movements under load!

VIP-Swivel adapter for DEMAG hoists VIP-Hoist swivel adapter. - Equipped with original Demag ball bearing. - Made of high-strength tempered special steel. - Tested according to EN 1677. - Suits 1-leg chain blocks and 2-leg bottom blocks. - Suits all VIP-Clevis connection kit parts. - The 6 mm clevis connection suits also IAGH-6 ICE-Automatic hooks. - The lifting point can be rotated by 360°. However, this is not to be equated with rotating and turning under load! - Ball bearing: suitable for rotating and turning. However, not suitable for permanent turning movements under load!

About lifting and hoist chain

Grade 80, 100 and higher alloy chain and chain slings rated for overhead lifting.